Ground rail line refrigerator and freezer door body foaming fixture,PU Foaming Fixture
  • Ground rail line refrigerator and freezer door body foaming fixture,PU Foaming Fixture
  • Ground rail line refrigerator and freezer door body foaming fixture,PU Foaming Fixture
  • Ground rail line refrigerator and freezer door body foaming fixture,PU Foaming Fixture
  • Ground rail line refrigerator and freezer door body foaming fixture,PU Foaming Fixture
0 1 2 3

Ground rail line refrigerator and freezer door body foaming fixture,PU Foaming Fixture

  • products detail
  • Product Parameters
  • Working environmenttemperature 0℃~45℃,relative humidity is not more than 90%.
    Cylinder working pressure(bleed pressure) of core-pulling mechanism0.5MPa~0.7MPa
    Electric heating systemVoltage 220V or 380V,frequency 50Hz
    Water cycle heating systemwater temperature 50℃~70℃,pressure ≥0.05MPa
    Mold working temperature40℃~60℃
    Air holesdiameter is φ3mm~φ4mm, the number is 4 ~6
    Surface roughness requirements for mold formingRa≤1.6mm
    Mold materialCast aluminium alloy ZL105,LY12
    mold wall thickness≥15mm
    Gap between mold and product ≥0.5mm


    Working environmenttemperature 0℃~45℃,relative humidity is not more than 90%.
    Cylinder working pressure(bleed pressure) of core-pulling mechanism0.5MPa~0.7MPa
    Electric heating systemVoltage 220V or 380V,frequency 50Hz
    Water cycle heating systemwater temperature 50℃~70℃,pressure ≥0.05MPa
    Mold working temperature40℃~60℃
    Air holesdiameter is φ3mm~φ4mm, the number is 4 ~6
    Surface roughness requirements for mold formingRa≤1.6mm
    Mold materialCast aluminium alloy ZL105,LY12
    mold wall thickness≥15mm
    Gap between mold and product ≥0.5mm


  • Working environment:
    relative humidity is not more than 90%
    Electric heating system:
    Voltage 220V or 380V,frequency 50Hz
    Water cycle heating system:
    water temperature 50℃~70℃,pressure ≥0.05MPa
    Mold working temperature:
    40℃~60℃
    Air holes:
    diameter is φ3mm~φ4mm, the number is 4 ~6
    Surface roughness requirements for mold forming:
    Ra≤1.6mm
    Mold material:
    Cast aluminium alloy ZL105,LY12
    The mold wall thickness:
    ≥15mm
    Gap between mold and product:
    ≥0.5mm